Wireless
9 Item(s)
List Grid
-
900MHz Duck Antenna RP-SMA
900/1800 MHz Duck Antenna 2dBi with regular RP-SMA RF connector. Perfect for use with the XBee 900MHz units.
50 ohm impedance. 105 mm long. -
Arduino Xbee Shield
The Arduino Xbee Shield Wireless Module allows an Arduino USB board to communicate wirelessly using a Zigbee Xbee wireless module. It is based on the NEW Maxstream Series 2 XBee™ ZigBee OEM RF Module that can communicate up to 100 feet indoors or 300 feet outdoors (with ...
-
Bluetooth Mate Gold
The Bluetooth Mate Gold is designed specifically to be used with our Arduino Pros and LilyPad Arduinos. These modems work as a serial (RX/TX) ... -
XBee Adapter kit - v1.1
This adapter board is designed to make adding wireless point-to-point or mesh networking easy.
XBee Adapter kit does not include an XBee module and comes unassembled. -
XBee Explorer Dongle
This is the Xbee Explorer Dongle unit for the XBee line.
You get the red board only. XBee modules sold below, in the recommended items page. -
XBee Explorer USB
This is a simple to use, USB to serial base unit for the XBee line.
You get the red board only. XBee modules and USB cable sold below, in the recommended items page. -
XBee Pro 900 RPSMA
The XBee-PRO 900 RF module is ideally suited for low-latency point-to-multipoint networking applications.
Capable of point-to-point, peer-to-peer and point-to-multipoint networking, the XBee-900 is ideal for solutions where RF penetration and absolute transmission distance are paramount to the application. -
XBee Pro 900 Wire Antenna
The XBee-PRO 900 RF module is ideally suited for low-latency point-to-multipoint networking applications.
Capable of point-to-point, peer-to-peer and point-to-multipoint networking, the XBee-900 is ideal for solutions where RF penetration and absolute transmission distance are paramount to the application. -
XtreamBee Board (No XBee included)
This is the most advanced and competitive XBee interface board you will find!
XtreamBee Board is breadboard compatible, has 4 status LED's (one selectable to display ASC or RSSI), built-in 3.3V power regulator, configuration solder jumpers and an unique feature that allows you set the device as Master or Slave FTDI mode with a simple slide of a switch!
9 Item(s)
List Grid
















