SparkFun Products

SparkFun Electronics official website
List Grid
-
€4.00 €3.83155mm F/F Premium Jumper Wires
These are 155 mm long jumpers terminated with female connectors on both ends. Comes as 1 package of ten jumpers (2 x red, black, green, blue, yellow). -
€4.00 €3.83155mm M/F Premium Jumper Wires
These are 155 mm long jumpers terminated as male to female. Comes as 1 package of ten jumpers (2 x red, black, green, blue, yellow). -
2x5 AVR ICSP Male Header
This is the common 2x5 male header seen on many AVR boards. -
4-Digit 7-Segment Display
This is a basic, 4-digit 7-segment display - green in color. It has a common anode. The display features one decimal point per digit, and individually controllable apostrophe and colon points.
Dimensions:- Overall Display: 40.18 x 12.8 mm (1.58 x 0.50")
- Digit Height: 10mm (0.39")
-
6 Pin Right Angle Female Header
Through-hole 6-pin right angle female header. -
6 Pin Right Angle Male SMD Header
6 Pin Right Angle Male SMD Header with 0.1″ spacing between rows and between pins. -
-
€1.15 €1.057-Segment Red LED Display
A basic 7-segment Red LED Display (SparkFun). Common anode. Two decimal points, but only the one on the right is wired.
Digit height is 0.6".
Overall height is 1". -
7-Segment Serial Display
The 7-Segment Serial Display turns the thirteen pins necessary to control a 4-digit 7-segment display into just one or three. The display will give you full control of all digits, decimal points, the colon and the apostrophe.
At the heart of the display is an ATMega168 which controls all the serial communications and the 4-digit 7-segment display through an easy to use API. -
7-Segment Serial Display - New Version
The 7-Segment Serial Display turns the thirteen pins necessary to control a 4-digit 7-segment display into just one or three. The display will give you full control of all digits, decimal points, the colon and the apostrophe.
At the heart of the display is an ATMega328 which controls all the serial communications and the 4-digit 7-segment display through an easy to use API. -
900MHz Duck Antenna RP-SMA
900/1800 MHz Duck Antenna 2dBi with regular RP-SMA RF connector. Perfect for use with the XBee 900MHz units.
50 ohm impedance. 105 mm long. -
9V Battery Holder
9V battery holder terminated with a standard 5.5 x 2.1mm, center-positive barrel jack, also features three mounting holes. -
9V to Barrel Jack Adapter
This simple cable has so many uses!
Plug a 9V battery into one end and connect the other end to anything with a 5.5x2.1mm, center-positive barrel jack. -
Arduino and Breadboard Holder
You've been waiting on this forever and here it is! This is a simple plastic plate that holds an Arduino (Duemilanove or Uno) and self adhesive clear breadboard. -
€15.60 €14.95Arduino MegaShield Kit
The Arduino Mega now has its very own prototyping shield! The SparkFun MegaShield mates with the Arduino MEGA board and gives the user a prototyping area, two general LEDs, and, most important of all, the Arduino MEGA reset switch is brought to the top level. The shield also works with our small breadboards if you don't want to solder to the prototyping area.
This Arduino ...
List Grid



















